MX Simulator

Stability 20
Fork Compression Dampening 55
Fork Rebound Dampening 70
Fork Spring Rate 53
Fork Preload 45
Fork Oil Level 40

Shock Compression Dampening 40
Shock Rebound Dampening 60
Shock Spring Rate 47
Shock Preload 50

Countershaft Sprocket +2
Rear Sprocket -2

Rider Mass Dist. 49

Leveling 20
Roll Dampening 41
Roll Limit Angle 180
Roll Limit Factor 7
Steering Dampening 45
Steering Strength 100
Max Steering Force 830
Direct Steering .88
Slow Damping Speed 40
Slow Damping Factor 3
Landing Damping Falloff 13
Laniding Damping Factor 1.25


Hope this helps someone seems to be a pretty universal setup for me, runs good in sx and pretty decent for any other track

Hey guys, Been playing Demo For about a month,And Got The Full Game Now, Just started SX and found it really tough,, but i managed to find a setup that made it alot easier,, So i though i would share it with you guys,, it was made from The Base SX setup that was poster earlier, so thanx to that dude for that, I only use this on the KTM 125 2 Stroke, , Which Id like to add is a amazing peice of work Well Done TO Those Guys/guy
And Tested (Horribly) By Me on Indianapolis SX, Which Also Is A Well Made Track!
I recomend You Get The MXS Bike Setup Application (v2.3 23-feb-2010)
And Just copy and paste, and save it as a new Scheme/setup (This Only Works For Full Game I Belive, Becuase Of Folder/file Names)

maybe a noob question but i'm a noob on mxs fot this moment
what is the best setup for a beginner on SX ?
i'm using arcade physics on because im training on arcade physics off but i feel that i not
can good ride with off
so what is the best setup for me you think ?
sorry for my bad english

geecomonster wrote:maybe a noob question but i'm a noob on mxs fot this moment
what is the best setup for a beginner on SX ?
i'm using arcade physics on because im training on arcade physics off but i feel that i not
can good ride with off
so what is the best setup for me you think ?
sorry for my bad english

I think You Should Try Lots Of Setups, look Above, But Without Arcade Mode, And If Possible Use a Controller, And have 100 Stability, Then When U dont fall so much, lower It By 10 and do the same, until u reach 20 then lower by only 3-4 Until you can ride great on 5 or something, and start With The 125 2 strokes

ok thnx i gone test some things
i practising with the arcade physics off but its hard to learn,but i gone training on it

Here is my SX setup I use everyday.
http://www.mediafire.com/?2yjy1dzjmmm

I am working on one now and like it a lot. It is super loose feeling but has a lot of traction yet still makes it through the whoops pretty well. The shock settings are straight up stolen from shack (this is what makes it behave well in the whoops). It still has a bit of a knifing problem though.



stability=20.000000
leveling=32.000000
roll_damping=72.000000
roll_limit_angle=45.000000
roll_limit_factor=5.000000
steering_damping=64.000000
steering_strength=100.000000
max_steering_force=1000.000000
direct_steering=1.000000
slow_damping_speed=10.000000
slow_damping_factor=1.500000
land_damping_falloff=0.125000
land_damping_factor=3.000000
arcade=No
front_brake=Antilock
rear_brake=Antilock
stop_wheelies=Front Only
auto_shift=No
auto_dab=Yes
sticky_dab=No
reverse_steering=Yes
lean_indicator=No
auto_clutch_rpms=5000.000000
brake_torque=400.000000
rear_brake_torque=160.000000
max_dab_speed=20.000000
front_sprocket_adjustment=0.000000
rear_sprocket_adjustment=2.000000
fork_compression_adjustment=66.000000
fork_rebound_adjustment=45.000000
fork_spring_rate_adjustment=50.000000
fork_preload_adjustment=50.000000
fork_oil_level_adjustment=25.000000
shock_compression_adjustment=25.000000
shock_rebound_adjustment=60.000000
shock_spring_rate_adjustment=15.000000
shock_preload_adjustment=25.000000
rider_yspring=50.000000
rider_ydamping=50.000000
rider_zspring=50.000000
rider_zdamping=50.000000
rider_mass_distribution=0.500000

stocksy129 wrote:feel free to post your setup here to help the newer guys out
Stability:15
Fork Compression Damping:85
Fork Rebound Damping:75
Fork Spring Rate:55
Fork Preload:50
Fork Oil Level:58

Shock Compression Damping:65
Shock Rebound Damping:65
Shock Spring Rate:50
Shock Preload:64

CounterShaft Sprocket:0
Rear Sprocket:-1

Rider Vertical Spring:75
Rider Vertical Damping:75

Rider Forward Spring:75
Rider Forward Damping:75

Rider Mass Distribution:0.49

Leveling:28
Roll Damping:37.50
Roll Limit Angle:50.25
Roll Limit Factor:3.75
Steering Damping:22
Steering Strength:100
Max Steering Force:500
Direct Steering:1
Slow Damping Speed:34
Slow Damping Factor:1
Landing Damping Falloff:0.09
Landing Damping Factor:1.38

I hope this helps some one

thanxs stocksy been having trouble with my setup thxs

Heres my setup:
stability - 0
leveling - 20
roll damping - 32
roll limit angle - 180
roll limit factor - 0
steering damper - 45
steering strenght - 100
max steering force - 1000
direct steering - 1
slow damping speed - 40
slow damping falloff - 0.50
Landing damping factor - 2.00

National setup bike:
fork compression damping - 50
fork rebound damping - 60
fork spring rate - 38
fork preload - 60
fork oil level - 40

shock compression damping - 50
shock rebound damping - 60
shock spring rate - 30
shock preload - 40

countershaft - 0
rear sprocket - 0

rider vertical spring - 50
rider vertical damping - 40
rider forward spring - 40
rider forward damping - 35
rider mass thingy - 0.50

supercross:

fork compression damping - 55
fork rebound damping - 60
fork spring rate - 69
fork preload - 60
fork oil level - 40

shock compression damping - 55
shock rebound damping - 60
shock spring rate - 60
shock preload - 40

countershaft - 0
rear sprocket - -1

rider vertical spring - 50
rider vertical damping - 40
rider forward spring - 40
rider forward damping - 35
rider mass thingy - 0.50

now that the supercross season is over, does anyone have a good outdoor setup to get ready for the either JLV's outdoor season or DRS Outdoors.

No motocross settings for me yet but I wanted to post my Supercross settings that I absolutely love. All I can say is, wow, the bike matters a lot in this game. The YZf has nice power but I can only get it to handle well on certain tracks. It usually ends up feeling 50 lbs heavier than the rest under braking, with the bakc sapping all over the place if the ground even hints at being bumpy. The other three handle well pretty much everywhere but I feel like they lack power compared to the YZf. Instead of changing my settings around I just leave this base setting and change the bike around to see which is best on a track. I like the behavior of this setup in turns so much I don't want to change anything, haha.

I was always washing out and having low traction issues but as soon as I put all preload, front and back, down to zero, a lot of that cleared up. Now I have lots of traction and can clear most of the shack lines.


bike=crf250(2009)

stability=20.000000
leveling=39.000000
roll_damping=73.000000
roll_limit_angle=53.000000
roll_limit_factor=5.000000
steering_damping=62.000000
steering_strength=100.000000
max_steering_force=1000.000000
direct_steering=1.000000
slow_damping_speed=10.000000
slow_damping_factor=1.500000
land_damping_falloff=0.125000
land_damping_factor=1.500000
arcade=No
front_brake=Antilock
rear_brake=Antilock
stop_wheelies=Front Only
auto_shift=No
auto_dab=Yes
sticky_dab=No
reverse_steering=Yes
lean_indicator=No
auto_clutch_rpms=5000.000000
brake_torque=400.000000
rear_brake_torque=120.000000
max_dab_speed=20.000000

front_sprocket_adjustment=-2.000000
rear_sprocket_adjustment=2.000000
fork_compression_adjustment=81.000000
fork_rebound_adjustment=13.000000
fork_spring_rate_adjustment=76.000000
fork_preload_adjustment=0.000000
fork_oil_level_adjustment=99.000000
shock_compression_adjustment=27.000000
shock_rebound_adjustment=66.000000
shock_spring_rate_adjustment=21.000000
shock_preload_adjustment=0.000000
rider_yspring=40.000000
rider_ydamping=45.000000
rider_zspring=40.000000
rider_zdamping=51.000000
rider_mass_distribution=0.420000

Heres my easy to ride setup. I made it in one go so of course there is room for improvement, but ive ridden with it for some time and it feels really stable. Especially on the harder tracks like Mantova etc. I made it for those like me who have an old shitty controller or kb and/or are tired of crashing to much.. Would be nice if someone is willing to try it and give me some feedback... and you can still whip it big so dont worry about that.

stability=35.000000
leveling=20.000000
roll_damping=57.500000
roll_limit_angle=45.000000
roll_limit_factor=8.750000
steering_damping=55.000000
steering_strength=85.000000
max_steering_force=400.000000
direct_steering=1.000000
slow_damping_speed=40.000000
slow_damping_factor=1.375000
land_damping_falloff=0.218750
land_damping_factor=1.875000
arcade=No
front_brake=Antilock
rear_brake=Normal
stop_wheelies=Front Only
auto_shift=No
auto_dab=Yes
sticky_dab=No
reverse_steering=Yes
lean_indicator=No
auto_clutch_rpms=5000.000000
brake_torque=500.000000
rear_brake_torque=450.000000
max_dab_speed=20.000000
front_sprocket_adjustment=1.000000
rear_sprocket_adjustment=-2.000000
fork_compression_adjustment=100.000000
fork_rebound_adjustment=0.000000
fork_spring_rate_adjustment=50.000000
fork_preload_adjustment=50.000000
fork_oil_level_adjustment=50.000000
shock_compression_adjustment=0.000000
shock_rebound_adjustment=100.000000
shock_spring_rate_adjustment=50.000000
shock_preload_adjustment=50.000000
rider_yspring=0.000000
rider_ydamping=100.000000
rider_zspring=100.000000
rider_zdamping=100.000000
rider_mass_distribution=0.330000

how are you guys getting preload stuff and oil crap mine dosent have that stuff do i need to download somthing?

You need to download the latest snapshot. It can be found here : http://mxsimulator.com/benchracing3/vie ... f=1&t=5370

Hey i was just wondering how you guys have the save and upload windows in you setup menu?